Foam Sanding Block for Epoxy Resin and Contoured Surfaces – 70x100x25mm

Can be used wet or dry for sanding almost any type of material, flat or contoured. 70 x 100 x 25mm.
Bonded silicone carbide

Bonded silicone carbide
Use wet or dry
For flat or contoured surfaces

How to Use a Foam Sanding Block with Epoxy Resins

Allow the Epoxy to Cure: Ensure that the epoxy resin has fully cured and hardened before sanding. This will prevent the resin from smearing or becoming uneven.

Begin Sanding: Gently rub the foam sanding block over the epoxy surface in a back-and-forth or circular motion. Apply light, even pressure to avoid creating new scratches or uneven areas.

Check Your Progress: Periodically wipe the surface with a clean, dry cloth to remove sanding dust and check the smoothness. This will help you gauge how much more sanding is needed.

Clean the Surface: After achieving a smooth finish, clean the epoxy surface thoroughly to remove any remaining dust. This can be done with a damp cloth followed by a dry cloth to ensure no moisture remains.

Inspect and Finish: Once the surface is clean and dry, inspect it to ensure it’s free of imperfections. If needed, you can apply a new coat of resin or polish the surface for a glossy finish.